Homeowners' pick for heating and cooling across north Florida and the Suwannee Valley
Zoning Controls
We install and repair zoning controls, the dampers, zone panels and thermostats that let one heating and cooling system hold different temperatures in different parts of a house. Homeowners across Florida, Georgia and South Carolina call us when the back bedrooms run hot while the living room is freezing, or when an existing zone board has quit and one area gets no air at all. Call us and describe which rooms are off and by how much, and we will come out and look at the ductwork and the controls together.
Call (888) 381-2953- Real people on the phone
- 7 days a week
- Quote in writing before any work
Taking calls until 5:00 PM ET
What a zoning job involves
Zoning splits your duct system into two or more areas, each with its own thermostat and a motorized damper in the trunk or branch line. A zone panel reads the thermostats and tells the dampers to open or close, then signals the air handler or heat pump to run. On a retrofit we get into the attic or crawlspace to find room for the dampers, run control wire back to the panel, and set the bypass or airflow strategy so the system is not being choked when only one zone calls.
What we check and install
We start with static pressure and duct layout, because zoning a system that is already short on return air will make comfort worse. We check blower capability, existing thermostat wiring, and whether your equipment is single stage or variable. Then we install dampers, the zone panel, and thermostats sized to the areas you actually use. Older systems get a look at damper motors and end switches first, since a stuck damper is a common repair and cheaper than a full new control setup.
How we decide zoning is the right call
Sometimes it is not. A two-story home with a big temperature split, or an added room over a garage, is usually a real zoning candidate. But leaky return ducts, a crushed flex run, or a badly undersized branch will look like a zoning problem and will not be fixed by dampers. We measure airflow room by room before recommending anything. If sealing duct or adding a return solves it, we say so, and you keep a simpler system with fewer parts to fail.
Other thermostat installation work
The same on every visit
Written quote before any work
Covering 89 cities across Florida, Georgia, South Carolina.A real person answers
Open 7 days, 8:00 AM to 5:00 PM ET.Independent of every manufacturer
Carrier, Trane, Lennox, Goodman and more. We are not an authorized dealer for any of them.Zoning Controls — quick answers
Can I add zoning to my existing heat pump?
Often yes, if the ductwork has room for dampers and the blower can handle reduced airflow. We check static pressure and duct layout first, because zoning a strained system can shorten equipment life.
Why does one zone blow no air at all?
Usually a failed damper motor, a broken end switch, or a zone panel that lost power. Confirm the thermostat has fresh batteries and the breaker is on, then call us to test the panel and damper.
Do I need a separate thermostat for each zone?
Yes. Each zone needs its own thermostat so the panel knows which area is calling. We match thermostats to the zone panel and to whether your system is single stage or variable speed.
How it works
- Step 1
Tell us the symptoms
You describe what changed. No cold air, a breaker that keeps tripping, water near the air handler, a smell, a noise. That gives us a head start on parts before we ever leave the shop.
- Step 2
We diagnose on site
A technician checks the thermostat, the electrical side, airflow through the filter and coil, refrigerant behavior and the outdoor unit. We look at the whole system, because a frozen coil usually points somewhere else.
- Step 3
You decide the repair
We explain what failed, what it takes to fix it, and how long the rest of the system is likely to hold up. You pick the repair. We do not start work you did not approve.
- A real person answers
- Open 7 days
- Written quote before work starts
Why homeowners call us
- Rural routes are normal for usWe drive long stretches between calls and we plan for it. Trucks carry the common heat pump and air conditioner repair parts so a diagnosis does not turn into a second trip on a hot afternoon.
- Heat pumps and sandy soilMost homes we visit run a heat pump, and sand, lawn clippings and pollen pack the outdoor coil fast. We clear it, check the defrost side in winter, and show you what we found before we close it up.
- Well water housesHomes on well water bring their own quirks, from pump-driven electrical noise to hard water on drain lines and condensate pans. We know where those systems clog and where the slow leaks hide.
- Heating repair tooCold snaps in this region are short and hard. We do heating repair and heater repair on heat pumps, strip heat and furnaces, so one crew handles your system in July and again in January.
- All major brands, gas & electricOne independent crew for Carrier, Trane, Lennox, Goodman, Rheem and more.
- Straight answersIf a system is not worth repairing, we say so, often right on the phone.
Zoning Controls
Ready to book zoning controls?
Describe the system and your ZIP. The written quote comes before any work.
- A real person answers
- Open 7 days
- Written quotes
- All major brands
- Gas & electric
Rather not call? Get a free quote →